iTECH200

Deep Cycle Lithium Battery

LiFePO4 200Ah 12V

The iTECH200 200 amp lithium battery supports pure sine wave inverters up to 3000W. This means you’re able to run sensitive electronics, fridges, microwaves, and even power tools if you need to. It will work with most inverter brands, but pairing it with an iTechworld inverter means you’ll be able to plug-and-play whenever you need to. Its high discharge rate means it easily powers large inverters where AGM or budget lithium batteries would struggle.

The Redback™️system uses advanced Battery Management System (BMS) technology that constantly balances prismatic LiFePO4 cells. For you this means your 200 amp lithium battery is protected against over-voltage, under-voltage, short circuits, and thermal issues. This design enables your battery to last longer and ensures it’s always safe to use. 

Yes. Everything we make is designed and tested right here in Australia, and our 200 amp lithium battery is no different. It loves nothing more than being used in the harsh Aussie conditions and that includes salt air and vibrations at sea. Thanks to the lightweight design and IP67 waterproofing in the X-Range, iTechworld batteries will also have boating and marine users covered

Still, to help your rig last that little bit longer, always think about mounting it in a ventilated compartment and make sure any terminals are protected from direct saltwater spray.

The iTECH200 is built for Australian extremes, from red dust and desert heat to cool alpine nights. While cold may make charging a little slower, and extreme heat may shorten the lifespan if not ventilated, the internal BMS provides over-temperature protection to keep your battery safe.

Absolutely. Prismatic LiFePO4 cells are much more stable than regular cylindrical cells, and the housing is reinforced to deal with corrugations and shocks. This makes it a great fit for 4WDers, van-lifers, and tradies travelling any rough tracks.

Pair the iTECH200 200 amp lithium battery with a lithium-compatible DC-DC charger (such as the iTECHDCDC40) or an AC charger (like the iTECHBC40) to make charging quick and simple. Solar users should also go for an MPPT regulator to get the maximum possible harvest. Unlike AGM batteries, you can use 100% of the iTECH200’s capacity, so faster recharge cycles mean longer off-grid adventures.

Our 200 amp lithium battery can be configured in either series (to increase voltage) or parallel (to increase capacity). However, you shouldn’t mix both at once. Always use identical batteries of the same age and model, and make sure the cables and fuses are correctly rated for your load.

At just 27kg, the iTECH200 is a fraction of the weight of AGM equivalents (which can easily exceed 120kg). This makes it much easier to pick up, move and install, and leaves more payload capacity for the rest of your gear; something that’s critical for caravans, 4WDs, and boats.

Thanks to its low self-discharge rate (≤2%), the iTECH200 can sit unused for months without going flat. For the very best results, store yours at around the 50–70% charge mark, check it over every few months, and top up if needed.

The BMS constantly balances individual cells, keeping them equalised to help prevent any weak spots. This means the battery always delivers full usable capacity, remains efficient under heavy loads, and stays safe even in any challenging conditions you might encounter on your adventures.

The iTECH200 works with most existing 12V solar setups. For the best results, use an MPPT controller and pre-wired accessories like battery boxes or wiring kits to simplify installation. Its rugged case and outdoor-mounting capability make it adaptable to caravans, camper trailers, or off-grid homes.